Vacum for lifting and installation wall and roof panels Cladding lifter CL1-8 500 kg

Cladding lifters

CL1-8 500 kg

Vacuum lifter CL1-8

Dual vacuum circuit

• For vacuum lifters intended to be used in a building area, the regulations EN 13155 required a secondary positive holding device or there shall be two vacuum reserves each fitted with non return valves.
• Each vacuum reserve shall be connected to a separate set of vacuum pads.
  
• Righetti’s specific vacuum lifters for construction site use meet the requirement of EN 13155 and are complete of two separate vacuum circuits.

Removable batteries

• Righetti battery vacuum lifters are powered by built-in rechargeable batteries and on quite all models the batteries, if necessary, can be easily removed and quickly replaced.
  
• To have the additional battery pack can be really useful in case the operators forgot to charge the batteries or for some reason is not possible to put the lifter under charge.
• Battery powered vacuum lifters are suplied complete of 220 Volt battery charger.
  
• The level of the battery charge can be control on battery gauge that costantly indicates the current battery level.
  

Parking stand included

• Vacuum cladding lifter CL1 comes complete of parking stand.
  
• The parking stand permits to transport the vacuum lifter with reduced space of only cm 80×100.
• The parking stand of caldding lifter CL has the possibility to be moved by fork lift

Vacuum Control Unit

• An on-board computer to manage the lifter as safely as possible verifies the operation of the lifter’s main components and carries out self-diagnostics if a breakdown occurs.
• The control unit comes complete with microprocessors to control the power circuits.
  
• It monitors the level of vacuum in the system, reporting any anomalies with a visual and acoustic warning.
  
• It manages and monitors the batteries.
• Besides showing how much battery is left, the on-board computer controls and protects the batteries, clearly warning the operator with sequential alarms when power is at minimum level.
• A built-in economizer considerably lengthens battery life.
• Safety of the vacuum system – consult how the lifter works

Vacuum lifter CL1-8

For lifting and installation of sandwich panels
smooth, with ribs and with micro-ribs

• max capacity 500 kg
• powered by on board batteries, rechargeable and
  interchangeable
• suction and release command activated by
  manual sliding valve on lifter's frame
• 8 suction pads mm 800x120 with shaped gaskets
  specific for sandwich panels
  
• 2 removable extension arms
• dual vacuum circuit EN13155
• vacuum control unit PLC and safety devices

Roof and wall panels vacuum lifter